CW61100D-CW61125D-60HZ Conventional Lathe

The CW61100D-CW61125D-60HZ is catalogued with max. length of workpiece options of 1000, 1500 and 2000–12000 mm. Work from your longest finished part plus chucking and parting allowance, and remember slender work on the longer beds wants steady rests quoted with the machine. Buying excess bed costs floor space and money every day after delivery.

The CW61100D-CW61125D-60HZ carries a 130 mm spindle bore diameter. Remember usable bar capacity always runs smaller than the bore itself once the chuck or collet mechanism is in place, so check your maximum bar stock against the workholding you intend to run, not against the bore figure alone.

Two build points matter most on this machine: one-piece high-strength cast iron bed for rigidity and accuracy; and way surfaces hardened by ultrasonic-frequency quenching. Structure decides how a machine ages — the specification table tells you what it does new, the build tells you what it does in year five.

Both sit in the conventional lathe group, so the decision is capacity and duty, not kind: put your largest part dimensions, material and yearly quantity against each specification table and one of the two will run out of a figure first. Send the drawing and we will name which of the two fits — including the case where the smaller machine does the job.

Every CW61100D-CW61125D-60HZ is laser-measured to ISO 230-2 over its travels, cuts a test piece that is measured rather than admired, and ships with a serial-numbered report carrying the measured values. If any line misses, the machine goes back into the shop until it passes — the report is a record, not a promise.