Get A Quote

Company 1 min read

Hand Scraping: Why The Last Micron Is Still Done By Hand

A ground surface looks flat and is not. Scraping puts the contact points where the load is and leaves the pockets that hold the oil film.

Hand scraping a machine tool table, engineer's blue showing the contact points

Want to see how the machines behind this article are built and tested? Ask and we will arrange it.

Ask An Engineer

Related Notes

All articles
  1. High-performance CNC vertical machining centre on the shop floor Technical

    Improving Manufacturing Efficiency With High-Performance CNC Machines

    Cycle time is the number everyone quotes, but setup, tool change and chip clearance decide what a machine actually produces across a shift.
  2. Five-axis CNC machining an aluminium part with flying sparks Technical

    How 5-Axis CNC Machining Enables Complex Part Manufacturing

    When a part genuinely needs simultaneous five-axis, and the cases where 3+2 positioning does the same job for considerably less money.
  3. CNC machining workshop with rows of vertical machining centers Technical

    The Future Of CNC Machining: Driving Precision Manufacturing Innovation

    Where machine tool building is actually heading: tighter thermal control, more measurement built into the machine rather than bolted on afterwards, and controls that tell you what the spindle is doing before a bearing fails.

Rather See It Than Read It?

Acceptance testing happens on our own floor and visitors are welcome to watch it. Send us a part and we will cut it while you are here.

Book A Factory Visit Inside The Plant
+86 15162661999 info@hankray.com