JHT-800 Horizontal Machining Centre

The JHT-800 carries a 630×630 / 800×800 / 1250×1000 mm table. Size against the fixture, not just the part — as a working rule allow roughly one and a half times the part footprint once workholding is on, and check the load rating against part plus fixture weight. A dense casting can max a table long before it runs out of area.

Two build points matter most on this machine: the casting adopts an integrated box design with a dual ribbing arm structure, giving optimal support and dynamic stability; and all three axes run ball linear slide rails with a low friction coefficient, and the rail span follows a golden-ratio distribution for accurate, smooth cutting feed. Structure decides how a machine ages — the specification table tells you what it does new, the build tells you what it does in year five.

Both sit in the horizontal machining centre group, so the decision is capacity and duty, not kind: put your largest part dimensions, material and yearly quantity against each specification table and one of the two will run out of a figure first. Send the drawing and we will name which of the two fits — including the case where the smaller machine does the job.

Every JHT-800 is laser-measured to ISO 230-2 over its travels, cuts a test piece that is measured rather than admired, and ships with a serial-numbered report carrying the measured values. If any line misses, the machine goes back into the shop until it passes — the report is a record, not a promise.